What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
10.06.2025 12:00
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is the picture of an electronic coil of wire wound around a core of magnetic material.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
It seems Mohan does not understand the difference between a comment and an Answer.
but I think this circuit , shows a few more pieces.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
How can you tell if someone is cunning?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
An AC voltage/ current source, and an ac inductive load.
Scientists identify two global ocean bands heating at record rates - Earth.com
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
nine
For this case there are devices called Metal oxide varistors (MOV).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Putin's uncompromising demands emerge after the latest round of Russia-Ukraine peace talks - AP News
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
These are simplified answers to the original question, and does not change anything I wrote above.
Edit 2024–10.
Have you ever accidentally found out that you were about to be fired?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
These devices are installed between the “hot” and “neutral” and protective ground.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Why do people who were very kind and loving once become cold-hearted?
It also is a device that limits the change in current flow.
This is 'the assistant's answer'
At one ohm, the resistor has a maximum of 1 watt power.
Now when you have a certain ac resistance, then a current flows in a loop.
He then describes the function of a fuse.
Here is a simplified AC power diagram.
How often do you watch the news on TV?
First Sentence:
One is “what exactly is in a ‘surge protector’ ? ”
Barnstars:
Winners & Losers From The 2025 NCAA Baseball Tournament Regional Round - Baseball America
The third is lightning and “how it gets conducted into a home.”
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
What is lightning?
Vancouver Whitecaps lose Concacaf Champions Cup final to Cruz Azul - MLSsoccer.com
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–14 [Omar Gharbi Omar Gharbi ]
There are two important concepts here.
Post-COVID Fatigue: Is Your Gut To Blame? - SciTechDaily
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This one hit behind the barn.
2024–10–10[John johnson John Johnson ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
United says it will slash Newark fares to win back travelers after airport chaos - NJ.com
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
[image of Common-mode choke]
The other is “what does a “fuse” do?”
He then asserts :
A circuit breaker is similar, but is resettable.
The bolt then partially travels down the line to your home.
A fuse is a non-resetable over current circuit protector.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
the problem then depends on "how fast does the fuse operate?".
but this device (an Inductor) … impedes the rapid changes in the current.
This is where this question deviates from being a 'generic' question, and becomes more specific.
eight
(Dc diagram shown, AC is similar).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
a photo is worth a thousand words.
He then describes Rainy Season and Lightning.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This is where the MOV conducts again, and dissipated the energy.
But it can get overloaded, and no longer works.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Upvotes:
what exactly is a ‘surge’ protector?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
At least they know the answer if they wanted it.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
I post the exact comment here.
[old diagram got deleted by accident]
This device then solves the entire problem.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
What does a fuse do?
There are three different concepts here that are getting confused.
In schematic diagrams this is the symbol for a fuse:
So, the voltage could go up to 500 volts, and the fuse will not open up.
One
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
so, what happens?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.